This is similar to adjusting the bass control on a stereo. The gain control sets the amount of low-frequency boost or cut. When the spectral selection begins at 0 Hz or its lower bound is undefined, this effect applies a low frequency shelving filter with the half-gain frequency (the mid-point of the gain section of the curve) defined by the upper boundary of the spectral selection.When the track is not in Spectrogram View with Spectral Selection enabled, an error message will be displayed.Use these filters when you do not want to reduce the lowest bass or highest treble frequencies in the spectral selection as much as you would with a standard high pass or low pass filter, or if you actually want to boost either the low or high frequencies respectively.ĭepending on how the track is displayed and what spectral selection has been made, this effect will do one of the following: The Spectral edit shelves effect is used with a Spectral Selection to apply either a low-shelving filter or a high-shelving filter to the selection, depending on the type of selection made.Īccessed by: Effect > Spectral edit shelves.Ī shelf filter curve is flat at both ends rather than flat only at the frequencies being passed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |